RFC- conducted emissions kit

RFC- conducted emissions kit
This series of test systems incorporate an EMC analyser plus the interface to the cable under test. This interface will be either a LISN or Voltage Probe (for mains and power cables) or a telecomms cable interface. These kits are shipped complete to match the specific tests that are required, and can be used 'straight from the box'. When they are used with the pre-selector option, compliance-quality results are obtained.

Features

RFC- conducted emissions kit provides the following products:

1GHz EMC emissions Analyser      1GHz EMC emissions Analyser
      The SA1002 is a fully featured EMC emissions analyser for all EMC compliance measurements up to 1GHz
LISN & Voltage Probes      LISN & Voltage Probes
      These ancillaries enable compliant conducted emission tests. A wide range of LISNs plus voltage probe are available.
Ancillaries.. conducted      Ancillaries.. conducted
      

Filters and pre-amplifiers can be vital tools in the armoury when measuring conducted emissions.

CRS+      CRS+ (optional for this kit)
      The CRS+ is used to check the calibration and operation of conducted EMC emissions test equipment.
Pre-Selectors for EMC test      Pre-Selectors for EMC test (optional for this kit)
      

Pre-Selectors are an essential requirement if measuring conducted emissions that have high broadband noise content. They effectively convert an EMC Analyser into a receiver, as specified by CISPR16.

See Technical Paper for a fully explanation of pre-selectors and why they are important.

Associated Downloads

User manual - RF910 & RF915 - User manual for the pre-selectors
User manual - CRS+ - User manual for the Conducted Reference Source